NEWS CENTER


Pneumatic ball valve actuator failure causes and solutions


Release time:

2021-06-29

Pneumatic ball valveIt is one of the ball valves. It has a pneumatic actuator and a ball valve combined together. The pneumatic actuator controls the valve stem to drive the ball to rotate 90 degrees. Widely used in petroleum refining, long-distance pipeline, chemical, paper, pharmaceutical, water conservancy, electric power, municipal, steel and other industries, occupies an insignificant position in the national economy.

Pneumatic ball valve actuator failure causes and solutions

Pneumatic ball valveIt is one of the ball valves. It has a pneumatic actuator and a ball valve combined together. The pneumatic actuator controls the valve stem to drive the ball to rotate 90 degrees. Widely used in petroleum refining, long-distance pipeline, chemical, paper, pharmaceutical, water conservancy, electric power, municipal, steel and other industries, occupies an insignificant position in the national economy.
Pneumatic ball valve actuator leakage reasons:
1. The solenoid valve on the cylinder leaks, perhaps because the pressure in the pressure reducing valve is too high.
2. The exhaust hole of the cylinder leaks, because the two movable parts inside the cylinder and the sealing ring of the cylinder body are aging.
3. The upper and lower parts of the cylinder leak, because the sealing ring between the actuator and the cylinder does not reach the sealing effect because of the frequent activities of the actuator.
4. In addition to the above three conditions, there is another condition that may also cause the cylinder to leak air, that is, the spring in the cylinder is damaged, because the force is not in place, which may also be caused by not being in place. When dealing with the problem of cylinder air leakage, we must consider it according to the actual situation. For example, the valve is open or closed. For the valve with air opening, we can first close the hand valves at both ends, then let the central control open the valve, first disassemble the connecting piece at the connecting part, then cut off the air source, release the air at the pressure reducing valve at this moment, pay attention to the fact that the actuator will roll at 90 ℃ at this time, and be sure to move the actuator back to its original position in the future.
Treatment:
1. Replace the actuator seal.
2. Replace the sealing ring at the cylinder.
3. The pressure reducing valve pressure conditioning for 3-5kg, or the solenoid valve at the lower part of the open ventilation action several times, sometimes there may be replacement of the solenoid valve.
4. Replace the spring in the cylinder.